RF-Max Digimax 210 Podręcznik Użytkownika Strona 4

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 10
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 3
1 Open the unit by slackening the retaining screw situated in
the bottom edge and hinging carefully upwards. Disen-
gage the unit from the wall-plate and place it to one side
for safe keeping.
VI Configuring
The unit is supplied with a 5°C minimum temperature set
point and configured as a heating thermostat as factory de-
faults. Two internal links can be used to reconfigure these
defaults.
3 Remove the battery insulation strip and check unit is func-
tioning, place it on its wall-plate
V Fixing
1 The wall plate should be positionned with a minimum of
70 mm clearance all round to allow adequate air flow
2 Fix the wall-plate directly to a flat wall
The radio link does not mean that the wiring has been sim-
plified, but that the thermostat can be installed in any place of
your house to optimate your needs in heating.
We recommend you to make the installation with the receiver
RF-Max before fixing your thermostat on the wall, in order to
be certain of its good operation at the selected place.
IV Position
The ideal position to locate the DigiMax 210 Digital Room
Thermostat is about 1.5m above floor level, accessible, free
from extremes of temperature and draughts. Do not mount
on an outside wall, above a radiator or where it may be sub-
jected to direct sunlight.
Przeglądanie stron 3
1 2 3 4 5 6 7 8 9 10

Komentarze do niniejszej Instrukcji

Brak uwag